Paper Folding : Typically, there are only two basic types of folds: parallel and right-angle. Products containing parallel folds consist of folds that run parallel to each other. Right-angle folds are folds that run perpendicular to each of the preceding folds.
Common Parallel Folds
Types of Folding Equipment
A variety of different folds are now being accomplished on many different shapes and sizes of printed materials. Paper and other substrate products can be folded either in-line during the production of the printed piece or off-line on folding machines ranging from free standing table-top folders to high speed production floor models.
In-line folding is generally best for large quantity products. Folding inline may result in lower press speeds, however the reduced speeds are accepted for the economies gained. It eliminates the additional cost of folding the product with an offline process. In-line folding is limited to only a few types of products and a few types of folds. Off-line folding or bindery folding provides the greatest number of different folds on high-speed machines referred to as knife folders, buckle folders or combination folders.
A knife folder is used primarily for booklet work due to the accuracy that can be achieved when producing right-angle folds, keeping the pages in close registration. A blunt steel blade pushes the internal part of the paper at the desired location between two rollers to create the fold in the material. The knife folder is a slower speed folder, but as stated, more precise on the folds.
A buckle folder, the most common type of folder, uses a set of guides and plates with a “backstop” to buckle the paper and create the fold. The document enters through a set of rollers and into a plate where the paper strikes a backstop as shown in the illustration at the right.
When the paper strikes the backstop, it buckles and is forced downward and into a set of nip rollers.
The nip rollers grab the sheet at the buckle and pull it through, compressing a fold into the sheet as it passes through the rollers. If several folds are desired, then the material is sent into another plate to repeat the process. The fold or buckle location is adjustable by altering the stop mechanism. This allows for different folds to be created depending upon the type of fold required.
A combination folder, as the name implies, provides both close registration and a higher speed for folding. The combination folder is used most often for large quantities and more complex folding jobs.
